Acnodes FPC 6104 Instrukcja Użytkownika Pobierz pdf (Strona 31)

661 Brea Canyon Rd., Suite 3

Walnut, CA 91789

tel: 909.598.7388, fax: 909.598.0218

are subject to change without notice. For latest product information,

please visit Acnodes’ web site at www.acnodes.com.

FPC 6104

10.4” Industrial fanless Panel PC

4.10.1 ACCESS THE JUMPERS

To access the jumpers, remove the back panel. To remove the back panel, please refer

to Section 4.5.

4.10.2 Preconfigured Jumpers

WARNING:

Do not change the settings on the jumpers in described here. Doing so may disable or

damage the system.

The following jumpers are preconfigured for the FPC6104. Users should no change

these jumpers (Table 4-2).

4.10.3 AT Power Select Jumper Settings

NOTE:

The AT Power Select Jumper is the same as the ATX Enable connector.

Jumper Label: ATXCTl1

Jumper Type: 3-pin header

Jumper Settings:See Table 4-3

Jumper Location: See Figure 4-16

The AT Power Select jumper specifies the systems power mode as AT or ATX. Use a

jumper cap to short pin 1 - pin 2 on the ATXCTL1 connector to enable the AT Power

mode on the system. In the ATX mode use the PS_ON- and 5VSB cable. AT Power

Select jumper settings are shown in Table 4-3.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 111 112

Brak uwag

Acnodes FPC 6104 Instrukcja Użytkownika Strona 31